Cold Spots, Patchy Heat? Your System May Just Need a Flush.
A power flush clears the sludge, corrosion and old glycol clogging your in-floor heating system—before it becomes a much bigger problem.
Serving Whistler and the Sea to Sky
Glycol keeps your system from freezing, but it doesn’t last forever. Every five years or so it breaks down and turns corrosive, eating away at valves, pumps and manifolds from the inside.
We chemical flush first to break the sludge down, then power flush each zone until the water runs clear. Deeper than a power flush alone.
Corrosion can fail the in-floor lines themselves. Then it’s not a flush—it’s tearing up floors and tile to replace the piping, a job that can run into the hundreds of thousands of dollars.
A dedicated machine for both chemical and power flushing.
Trained in the UK, where it's part of routine maintenance.
One visit, no rearranging your day around it.
We’ll collect details about the issue, then get a visit scheduled.
We assess the system’s condition and connect the flushing equipment.
Clear each loop , refill with clean water and corrosion inhibitor, and verify proper flow.
Almost always one day, regardless of system size.
No, most of the work happens in the mechanical room. We’ll just need access to open and close a few valves or thermostats around the house.
Yes—we serve the Sea to Sky corridor, including Whistler, Squamish and Pemberton.
$2,495 + GST for the flush itself. Any repairs needed for parts that have already failed are quoted separately.
Every 3 to 5 years, depending on the age and condition of your system. If your system is 20 years or older and has never been flushed, it’s worth booking one regardless.
